Owner`s manual

UNIQUE UGP 6C/8C/10C DV
8
Fresh Air and Flue Exhaust Vent Location &
Assembly
 If not already done so locate the fresh air vent, flue exhaust vent and poly bag
containing high temp silicone from the back of the appliance and set aside.
 Decide where the fridge is to be located, it must be against an exterior wall
keeping in mind that included with the fridge there is 19" of available venting
from the exterior wall to the back of fridge. (can be cut down to fit
application)
 It's best to keep the location of the appliance as close as possible to the
interior wall for optimal operation.
 The next step will determine where the holes are to be drilled to accommodate
the fresh air and flue exhaust vents.
 Slide your fridge close as possible to the interior wall, now mark the bottom
position of the fresh air vent tube that is attached to the fridge on your inner
wall, also mark the top position with a pencil.
 Once you have done this go ahead and do the same for the flue exhaust pipe.
Note: the flue exhaust tube could be a slightly different height.
 Make sure you have leveled your fridge before the next step
 After both the fresh air and flue exhaust vents have been marked on your
interior wall, next find the center of each and mark. For the flue exhaust
increase the height of the center marking approx 3/8” this will allow the flue
exhaust tube to be on a slight angle upwards once installed. See Figure A on
next page.