User's Manual

Chapter 3 Installation
3 Installation
3.1 Introduction
T
h
is section describes the installation procedures for the DRU-2W, which is to be installed in
a restricted access location.
3.2 Components Installed at the Factory
T
h
e following components are installed in the Combined DRU cabinets prior to shipping.
Table 3-1 Combined DRU Components Installed at the Factory
Control Cabinet Part Number Quantity
PDU SX03-33300-01 1
Dual Band Pass Filter (DBPF) SX03-50100-01 1
Low Noise Amplifier (LNA) SX03-50200-01 1
BMS Mounting Shelf w/Controller SX03-50300-01 1
Break-Out-Board SX03-92020-01 1
HPA Cabinet Part Number Quantity
4-Way Splitter 000087234R 4 (2 per cabinet)
2-Way Splitter 000087315R 2 (1 per cabinet)
4-Way Hybrid Combiner w/Loads SX03-21825-01 4 (2 per cabinet)
PDU SX03-31300-01 2 (1 per cabinet)
Fan/Blower SX03-31600-01 2 (1 per cabinet)
Transmission Sub-system Controller (TSC) SX03-50700-02 2 (1 per cabinet)
HPA PSU Mounting Shelf SX03-51710-01 8 (4 per cabinet)
Magic Tee SX03-52100-01 2 (1 per cabinet)
HPA/TSC Transmit Output Coupler/RF
Detector
SX03-52350-01 6 (3 per cabinet)
Output Filter Network (OFN) Cabinet Part Number Quantity
Combined OFN, WG SX03-24100-02 1
LBD DR Filter SX03-51100-01 1
DRU Transmit Output Coupler/RF Detector SX03-51600-01 1
SX03-30000-01-M01
3-1