User's Manual

Chapter 2 System Description
2.3.15.2 2-Way Power Splitter
The 2-way,
0 deg., splitter is used to divide the exciter’s RF output signal, in order to drive
each set of four (4) HPA’s in the HPA sub-system.
Figure 2-28 2-Way Splitter
2.3.15.3 4-Way Power Splitter
The 4-way,
0 deg., sp
litter is used to further divide the exciter’s RF output signal, in order to
drive the four (4) HPA’s in each HPA sub-system HPA set.
Coaxial cables connected to the output of the splitter are cut to a pre-determined length in
order emulate a phased splitter.
Phase adjusters are connected to the splitter’s output legs in order to fine tune the phase
offset of each splitter leg / cable combination.
Figure 2-29 4-Way Splitter
SX03-30000-01-M01
2-31