User's Manual

Page 46
X75 SERIES - Mk3 Controller
INSTALLATION & OPERATING MANUAL
Manual No. x75mk3-11
x75-man-Rev11-0815.indd
13.6 NetworkSettings
Clicking on Network Settings loads to Controller Network Settings page. This page
is used to setup the Ethernet and E-Mail communications settings.
Figure28-NetworkSettingsWEBApplet(typical)
13.6.1-Ethernetsettings
The following settings set up the Ethernet interface.
IP Address – Use the spinner controls or directly enter values into the boxes to
congure the controller IP address. Default is 192.168.0.200
SubnetMask – Use the spinner controls or directly enter values into the boxes to
congure the controller subnet mask. Default is 255.255.255.0
GatewayIPAddress– Use the spinner controls or directly enter values into the
boxes to congure the controller Gateway IP address. Default is 0.0.0.0
Primary DNS – Use the spinner controls or directly enter values into the boxes to
congure the controller primary DNS. Default is 0.0.0.0
Secondary DNS – Use the spinner controls or directly enter values into the boxes
to congure the controller secondary DNS. Default is 0.0.0.0
Host Name – Enter the host name into this box. Default is blank.
Macaddress – Displays the MAC address of the controller.
EnableDHCP– If checked, the controller will communicate with a DHCP server
to obtain the network settings.