User's Manual Part 2

Chapter 6 Maintenance
6 Maintenance
6.1 Introduction
This section describes the procedures for removal and replacement of the DRU-200
components.
6.2 Test Equipment
The only test equipment required to perform the replacement procedures in the manual is a
PC/laptop. Operating instructions for test equipment are not included in this manual.
6.3 Required Tools
The following tools may be needed to perform maintenance on the repeater:
Table 6-1 Required Tools
Tool Type Size
Screwdriver Phillips #3
Screwdriver Phillips #2
Screwdriver Phillips #0
Screwdriver Slotted 1/4”
Screwdriver Slotted 3/16”
Screwdriver Slotted 1/8”
Screwdriver Slotted 3/32”
Hex Driver 3/16”
Hex Driver 5/32”
Hex Driver 9/64”
Security Hex Driver 3/16”
Open End Wrench 7/16”
Open End Wrench 11/32”
Open End Wrench 5/16”
Torque Wrench 5/16”
Socket 7/16”
Cable Tie PLT.7M-M 18lb, 3.1" x 0.090"
Cable Tie Mount ABM1M-A-C
Step Ladder
SX03-10000-01-M01 6-1