User's Manual Part 1

Chapter 3 Installation
SX03-10000-01-M01 3-46
3.14.3 Repeater Cabinet AC Power Connection
Figure 3-37
depicts the recommended repeater AC power connection.
Figure 3-37 AC Power Cable Routing
Repeater Pedestal
SiriusXM
DRU-200
PDU
Electrical Conduit
or BX Cable
AC Disconnect
Service Panel
Electrical Conduit
or BX Cable
• Arrange for the installation of an AC disconnect device on the repeater pedestal or in
close proximity to the repeater cabinet. The AC disconnect device must be connected
to the building/site electrical service panel according to all local and national electrical
codes.
• The AC power cable should be run to meet all local and national electrical codes, and
according to the repeater electrical drawing(s). This may require the cable to be run
inside electrical conduit between the building/site electrical service panel and the
repeater cabinet.