User's Manual Part 1

Chapter 3 Installation
3.10.1 S-Band Antenna
The following steps should be performed to connect the S-Band antenna (HBE RF input) to
the DRU:
1. Run a cable from the S-Band antenna to the DRU.
2. If the cable does not already have a male N connector on it, install a male N
connector on the end of the cable.
3. Attach and securely tighten the connector to the female N connector marked “S-
SAT”, which is located on the bottom-left side of the DRU – see Figure 3-29
.
3.10.2 Ku-Band Antenna
The following steps should be performed to connect the Ku-Band VSAT antenna (LBE RF
input) to the DRU:
1. Run a cable from the Ku-Band VSAT antenna to the DRU.
2. If the cable does not already have a male F connector on it, install a male F
connector on the end of the cable.
3. Attach and securely tighten the connector to the female F connector marked “V
SAT”, which is located on the bottom-left side of the DRU – see Figure 3-29
.
3.10.3 GPS Antenna
The following steps should be performed to connect the GPS antenna (LBE GPS input) to the
DRU:
1. Run a cable from the GPS antenna to the DRU.
2. If the cable does not already have a male N-type connector on it, install a male N-
type connector on the end of the cable.
3. Attach and securely tighten the connector to the female N-type connector marked
“GPS”, which is located on the bottom-left side of the DRU – see Figure 3-29
.
SX03-10000-01-M01 3-37