User's Manual Part 1

Chapter 3 Installation
3.9.3 Low Band Exciter (LBE)
During the installation procedure, a number of wires/cables must be connected to the LBE
rear panel. Please refer to Table 3-7
or drawing SX03-10900-03-D06.
The cables should be connected in the order that they appear in Table 3-7
.
Any RF cable, which is terminated with a SMA connector, should be
tightened with a 5/16” torque wrench to avoid over tightening and
damaging the cable connector or mating connector.
Figure 3-27 LBE Rear Panel
SX03-10000-01-M01 3-32