User's Manual Part 1

Chapter 3 Installation
Figure 3-1 Repeater Cabinet Top Down View
3.6.2 Installation Surface
The load bearing strength of the roof or floor where the repeater will be placed should be
taken into consideration. The repeater weighs approximately 825 lbs. and rests on an area
of 7.85 square feet of roof or floor space.
Before installing the repeater cabinet, check the installation surface structure, flatness and
suitability.
3.6.3 Repeater Cabinet Positioning
Over tipping the repeater may cause it to fall over, resulting in personal
injury or loss of life.
• The methods described in Section 3.6.1 can be used to move the repeater to the
required installation location.
• Unbolt the repeater’s feet from the pallet before attempting to remove it from the
pallet.
• Position the repeater according to site drawings (if available).
• The repeater must be bolted to a load frame, to the roof surface, or to the floor at all
sites to prevent possible tipping. Please see Figure 3-2
for mounting hole locations.
SX03-10000-01-M01 3-7