User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 FEATURES & OPTIONS
- 3.0 SAFETY WARNINGS
- 4.0 WARRANTY (summary)
- 5.0 UNPACKING AND INSPECTION
- 6.0 GENERAL SPECIFICATIONS
- 7.0 PRINCIPAL OF OPERATION
- 8.0 FRONT PANEL DESCRIPTION
- 9.0 REAR PANEL DESCRIPTION
- 10.0 LED Indicators
- 11.0 MAKING CONNECTIONS TO THE X75
- 12.0 INSTALLATION
- 13.0 USING THE CONTROLLER WEB BROWSER INTERFACE
- Appendix 1 – SNMP MIB Information
- Appendix 2 – Load LVD Configuration (model X75-12-A-GHHIL-S-578 only)
- Appendix 3 – Revision History
- Figure 1 - X75 Compact Integrated DC Power System
- Figure 2 - Block Schematic
- Figure 3a - Front View with Breakers (configuration A)
- Figure 3b - Front View with GMT Fuses (configuration B)
- Figure 4 - Rear Views of Base and Expansion Units
- Figure 5 - LED Indicators
- Figure 6 - Recommended Load Circuit Wire Sizes
- Figure 7 - Battery Temp. Probe & Alarm Relay Connector Pin-Out
- Figure 8 - Ethernet Connector Pin-Out
- Figure 9 - Auxiliary Connector Pin-Out
- Figure 10 - Input Current Ratings
- Figure 11 - Controller Status WEB Page (typical)
- Figure 12 - Rectifier Status WEB Page (typical)
- Figure 13 - Rectifier I²C Addressing
- Figure 14 - Controller Factory Calibration WEB Page (typical)
- Figure 15 - Controller Site Installation WEB Page (typical)
- Figure 16 - Alarm Configuration WEB Page (typical)
- Figure 17 - Controller Network Settings (typical)
- Figure 18 - Controller Alarm Log WEB Page (typical)
- Figure 19 - Controller Control Panel WEB Page (typical)
- Figure 20 - Controller System Settings WEB Page (typical)
- Figure 21 - SNMP Configuration WEB Page (typical)
- Figure 22 - Controller Help WEB Page (typical)
- Figure 23 - About UNIPOWER Telecom WEB Page (typical)
Page 25
X75 SERIES
INSTALLATION & OPERATING MANUAL
Manual No. x75-10b
x75-man-Rev10b-0514.indd
is closed and re-opened.
The controller has various network programming capabilities which allow it to be connected
to almost any conguration of IP network.
The default network settings that the controller is shipped with are:
IP Address – 192.168.000.200
Subnet Mask – 255.255.255.000
Gateway – 000.000.000.000
All pages served by the controller’s built-in WEB server consist of two frames; a ‘navigation’
frame on the left hand side and an ‘information/programming’ frame which occupies the
majority of the browser window.
The buttons in the ‘navigation’ frame can be used at all times to jump between the various
pages. Clicking on the UNIPOWER logo at the top will navigate directly to the UNIPOWER
web site www.unipowerco.com.
Each of the blocks of information in the ‘information/programming’ frame is a Java applet.
In some cases these applets simply collect information from the controller and presents it
on-screen, in other cases the applets contain data entry elds for uploading programming
information to the unit.
Note that a PC screen resolution of 1024 x 768 or higher is recommended to avoid excessive
amounts of page scrolling.
The following sections describe the various WEB pages that can be viewed with the browser
and give details of programming parameters that may be entered and sent to the unit.