User's Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 FEATURES & OPTIONS
- 3.0 SAFETY WARNINGS
- 4.0 WARRANTY (summary)
- 5.0 UNPACKING AND INSPECTION
- 6.0 GENERAL SPECIFICATIONS
- 7.0 PRINCIPAL OF OPERATION
- 8.0 FRONT PANEL DESCRIPTION
- 9.0 REAR PANEL DESCRIPTION
- 10.0 LED Indicators
- 11.0 MAKING CONNECTIONS TO THE X75
- 12.0 INSTALLATION
- 13.0 USING THE CONTROLLER WEB BROWSER INTERFACE
- Appendix 1 – SNMP MIB Information
- Appendix 2 – Load LVD Configuration (model X75-12-A-GHHIL-S-578 only)
- Appendix 3 – Revision History
- Figure 1 - X75 Compact Integrated DC Power System
- Figure 2 - Block Schematic
- Figure 3a - Front View with Breakers (configuration A)
- Figure 3b - Front View with GMT Fuses (configuration B)
- Figure 4 - Rear Views of Base and Expansion Units
- Figure 5 - LED Indicators
- Figure 6 - Recommended Load Circuit Wire Sizes
- Figure 7 - Battery Temp. Probe & Alarm Relay Connector Pin-Out
- Figure 8 - Ethernet Connector Pin-Out
- Figure 9 - Auxiliary Connector Pin-Out
- Figure 10 - Input Current Ratings
- Figure 11 - Controller Status WEB Page (typical)
- Figure 12 - Rectifier Status WEB Page (typical)
- Figure 13 - Rectifier I²C Addressing
- Figure 14 - Controller Factory Calibration WEB Page (typical)
- Figure 15 - Controller Site Installation WEB Page (typical)
- Figure 16 - Alarm Configuration WEB Page (typical)
- Figure 17 - Controller Network Settings (typical)
- Figure 18 - Controller Alarm Log WEB Page (typical)
- Figure 19 - Controller Control Panel WEB Page (typical)
- Figure 20 - Controller System Settings WEB Page (typical)
- Figure 21 - SNMP Configuration WEB Page (typical)
- Figure 22 - Controller Help WEB Page (typical)
- Figure 23 - About UNIPOWER Telecom WEB Page (typical)
Page 11
X75 SERIES
INSTALLATION & OPERATING MANUAL
Manual No. x75-10b
x75-man-Rev10b-0514.indd
8.0 FRONT PANEL DESCRIPTION
I
0
1 2 3
LOAD BREAKERS
I
0
I
0
I
0
I
0
CTR
MAJA
MINA
ACFA
RFA
OTA
OVA
CTR
MAJA
MINA
ACFA
RFA
OTA
OVA
12345
GMT FUSES
1.............................10
1 2 3
Figure3a-FrontViewwithBreakers(congurationA)
I
0
1 2 3
LOAD BREAKERS
I
0
I
0
I
0
I
0
CTR
MAJA
MINA
ACFA
RFA
OTA
OVA
CTR
MAJA
MINA
ACFA
RFA
OTA
OVA
12345
GMT FUSES
1.............................10
1 2 3
Figure3b-FrontViewwithGMTFuses(congurationB)
Figures 3a and 3b show the two system congurations as viewed from the front with breakers
and fuses respectively. Following is a description of each section.
8.1 From left to right there are 3 rectier slots. Each slot can accept one rectier from
the Sigma Series rated up to 650W output power. Only identical model rectiers of
appropriate output voltage may be installed at the same time. For example, a nominal
-48V system may contain between 1 and 3 model RSG48/10-Z OR between 1 and
3 model RSG48/12-Z but not a mixture of the two types.
8.2 To the right of the rectiers are 7 LED indicators which display various status and
alarm conditions. These are described in more detail in section 10.
8.3 On the right hand side of the unit is the DC distribution section which may contain
between 1 and 5 circuit breakers (conguration A) or a 10-way GMT fuse block
(conguration B).