Installation Guide

UNIQUE UGP 6F

3. Check that the spark is created by pressing the electronic ignition button on

the control panel.

4. Before removing burner orifice, clean burner area of any soot, scale or dirt

Remove the orifice and soak it in alcohol (isopropyl alcohol or thinners) and

blow it out with compressed air. Do not use thin objects to either clean or

unblock the injector. Re-install and tighten burner orifice.

5. Replace burner

Warning - DO NOT use a pin or wire when cleaning the

burner orifice as damage can occur to the precision opening.

This can cause damage to the freezer or create a fire hazard. It

will also create extremely dangerous levels of carbon

monoxide.

EXPLODED VIEW OF BURNER ASSEMBLY

Visually check burner flame to ensure you have a clean burning flame, this

is represented by a blue looking flame, a yellow/orange flame represents a

dirty burner or orifice and needs to be cleaned.

Baffle

VIEW OF BACK OF THE APPLIANCE