Use and Care Manual
23
6. Replace the cap back on the regulator
7. Next you will remove the grates, burners and
burner caps from the range to access the orices.
8. You will need a 7mm wrench to remove the
orices. Each orice can be accessed easily - the
larger burner orice is located on the burner wall.
9. Remove all LPG orices: place in the bag and
store in a safe place.
10. Take the NG orices provided and install them as shown below
See below for rating of orice for each model
Smallest Medium x 2 Largest Oven
NG 0.80 mm 1.36 mm 1.51 mm 1.88 mm
11. Once all the orices are installed, replace all burners and burner caps, then re
up the burners to check the minimum ame height.
12. Minimum ame height should be approx. ¼” tall. There is a small adjustment
screw located on the valve itself. The lid and the front control panel must be
removed to accomplish this adjustment.
13. Turn the valve fully counter clockwise. Then proceed to adjust the adjustment
screw counter clockwise for a smaller ame and clockwise for a larger ame.
Adjustment: Minimum ame should be approx. ¼” tall.
14. Temporarily replace the lid, burners, burner caps
and grates and recheck the ame. Once complete,
reassemble the control panel and the lid.
15. Next, the oven orice needs to be replaced.
16. Remove all racks, then the bottom pan by lifting up
the back rst to release the front then pull pan out.
17. Locate the burner tube and locate the retaining
screw at the front of the tube. Once this screw has
been removed, lift up the burner and pull away slightly to the right to expose the
oven orice.
GAS RANGE CONVERSION (continued)
BURNER ORIFICE
FLAME HEIGHT ADJUSTMENT
Adjustment location is
inside the valve stem
Adjustment location is inside the
valve stem
ORIFICE LOCATION