Use and Care Manual

NOTICE TO MASSACHUSETTS APPLIANCE DEALERS:

Be sure this document is included in all gas range appliances sold to consumers in

the State of Massachusetts.

NOTICE: Massachusetts law requires the following:

• Appliances must be installed by a licensed plumber or gas tter.

• Appliances must be connected with a three (3) foot (36” maximum length) exible

gas connector and

• A “T” handle type manual gas valve in the gas supply line to the appliance.

Have the dealer where you purchase your new range install it or have him

recommend a qualied installer. Installation must conform with local codes. In the

absence of local codes, the installation must conform with the National Fuel Gas

Code, ANSI Z223.1-Latest Edition in the U.S.A. or the CAN/CGA B149.1 or .2

Installation Codes in Canada.

The range should be connected to the supply line with 1/2-inch black iron pipe or

a certied exible type range connector. To prevent gas leaks, put an approved

sealing compound, which is resistant to liqueed petroleum gases, on all threaded

connections.

Important: Do not apply pressure directly to the range manifold pipe when

tightening supply connections. The manifold pipe should be held securely at the

pressure regulator to prevent twisting. Hold the pressure regulator with a wrench

during the tightening of the connection, or the manifold pipe may be twisted and

split, and cause a dangerous leak.

The installation of ranges designed for manufactured (mobile) home installation

must conform with the Manufactured Construction and Safety, Title 24 CFR, Part

3280, [formerly the Federal standard for Mobile Home Construction and Safety,

Title 24, HUD (Part 280)] in the U.S.A. or C.S.A. Standard CAN/CGA Z240.4.2 in

Canada or, when such standards are not applicable with local codes.

The installation of ranges designed for recreational vehicle installation must

conform to state or other codes and in the absence of such codes with the

standard for recreational vehicles ANSI A119.2.2–1982 in the U.S.A. or CAN/CGA

Z240.4.2 in Canada. The installation of appliances designed for recreational park

trailers must conform to recreational park trailers, ANSI A119.5.

NOTE: Check all piping connections in the unit for leaks. Never use an open

ame to check for gas leaks. Use a soap solution with a recommended ratio of

75% water and 25% dish washing soap. It’s possible for connections made at the

factory to leak, due to vibration encountered in transportation. Make certain you

have checked them all, and repair any connections that leak.

GAS CONNECTIONS