Full Product Manual

7
“Start-Up” Procedure
Electronic Ignition (battery)
1. To start the refrigerator, turn the thermostat knob E to the maximum setting, #4.
2. Turn button G to “Gas” position, then push B button in first and hold, proceed to
push in and hold the D button until you see the needle on the flame sensor C
moving from the red into the green area. Release the B button, while continuing to
hold in the D button for an additional 10-15 seconds, now release the D button.
The burner should now stay on indicated by the needle staying in the green area, if
not repeat the lighting instructions above.
3. Adjust the thermostat knob E to desired temperature setting after 8 or more
hours of operation.
4. To change the battery in the electronic ignition, turn the far left knob A to the
left to expose the battery, remove AAA battery and replace with a new one,
positive outwards, replace the knob by turning to the right to close.
Shut Down Procedure – Gas Operation
1. Turn selector knob G to the OFF position
2.
Shut the gas off at the LP-gas supply cylinder when the appliance is not in use.
3. If the refrigerator will not be in operation for a period of weeks, it should be
emptied, defrosted, cleaned and the door left open.
110V Operation
1. Ensure the electrical cord is plugged into a grounded outlet
2. Turn the selector switch G to AC position, AC power indicator F will
illuminate
3. To start the refrigerator, turn the thermostat knob E to the maximum setting.
4. Adjust the thermostat knob to desired temperature setting after 8 hours of
operation.
CONTROLS – See Fig. #5 for a description of controls