Specifications
4. For greater use of the printer
30
Printing can be automatically produced by sending a print command from the SI/F or RS-232C
interface to the M252A. Select whether this Automatic Print is ON or OFF.
Details of settings
ON........................... Printing is produced when a print command is sent from the SI/F or RS-
232C
interface. For the print commands from the SI/F and RS-232C inter-
face, see the instruction manual of each indicator and "RS-232C
interface(option)"(page 49).
OFF......................... Printing is not produced with a print command from the SI/F or RS-232C
interface.
■ For the print command from the SI/F, see the instruction manual of each connection indicator.
■ For the print command from the RS-232C interface, see "RS-232C interface(option)"(page 49).
Select whether or not to print at fixed intervals.
Name of setting 08: Automatic Print ON/OFF
Selection item 0. OFF
1. ON (initial value)
Caution
・Printing is always produced in the following conditions irrespective of
whether Automatic Print is ON or OFF.
・When the [PRINT] key is pressed.
・When the PRINT terminal and COM terminal to the rear panel are
short-circuited.
・Since an automatic print command cannot be given from the BCD
input, it is necessary to give a print command on the printer for
printing print data from the BCD input.
Name of setting 09: Interval Print ON/OFF
Selection item 0. OFF (initial value)
1. ON
Caution
Keys other than [STOP] (to stop Interval Print) and [ENT]
cannot be used during Interval Print.
08: Automatic Print ON/OFF
09: Interval Print ON/OFF