Specifications

INV2500-HS & INV5000-HS SERIES

OPERATING MANUAL

6.0 UNPACKING AND INSPECTION

6.1 This INV2500-HS or INV5000-HS was carefully tested, inspected and pack-

aged for shipment from our factory. Upon receipt of the unit, it should be

carefully unpacked and inspected for any damage in shipment.

6.2 If there is evidence of damage, do not attempt to test the unit. The freight

carrier should be notified immediately and a claim for the cost of the inverter

should be filed with the carrier for direct reimbursement. Be sure to include

the model and serial number of the damaged unit in all correspondence with

the freight carrier. Also save the shipping carton and packing material as

evidence of damage for the freight carrier’s inspection.

6.3 UNIPOWER Telecom will cooperate fully in case of any shipping damage

investigation.

6.4 Always save the packing materials for later use in shipping the unit. Never

ship the inverter without proper packing.

7.0 DESCRIPTION OF OPERATION

7.1 The INV2500-HS modules employ MOSFET and IGBT power semiconductor

switches with advanced, high-frequency, pulse modulation techniques to

produce a low-distortion, 50 or 60Hz sine wave output with 90% efficiency

and 7VA per cubic inch power density. A synchronization circuit lets two or

more inverter modules operate in parallel with their outputs in phase-synchro-

nization and current shared.

7.2 The INV5000-HS inverter system consists of two INV2500-HSs operated in

series for a 230VAC output at 5,000 volt-amperes (22A). The series connec-

tion of the units is made internally in the shelf. Each of the two inverter mod-

ules has its own input and output breakers, indicator LEDs and Form C relay

contacts. The two inverter modules in the INV5000-HS are different in that

their outputs are 180

out of phase with each other. Therefore these modules

must not be hot-swapped by the user.

7.3 Two INV2500-HS inverter modules in an INVR2U-HS shelf are automatically

connected in parallel in the shelf and become an inverter system with a

115VAC output at 5,000 volt-amperes (44A).

7.4 For the purpose of this manual, the INV5000-HS and two INV2500-HS