Specifications

INV2500-HS & INV5000-HS SERIES

OPERATING MANUAL

4.0 SAFETY WARNINGS

4.1 These telecom inverters have hazardous external and internal voltages. They

should be handled, tested and installed only by qualified technical persons

who are trained in the use of power systems and are well aware of the haz-

ards involved.

4.2 The input and output terminals are at hazardous voltage potentials. Do not

touch these areas when power is applied.

4.3 When operating these inverters, the chassis ground terminal must be con-

nected to safety ground to minimize electrical shock hazard and to ensure low

EMI (electromagnetic interference).

4.4 The internal voltages are at hazardous potentials. The inverter covers should

not be removed. There are no user-serviceable components in these units.

Removing the covers of the inverters will void the warranty.

4.5 WARNING: When using “floating neutral” (Option E) in the INV2500-HS

module or INV5000-HS system, the AC neutral output terminal “N” is

floating with respect to chassis ground. A neutral-to-ground connec-

tion must be re-established external to the inverter and be in

compliance with the requirements of the end-use application.

5.0 WARRANTY

All products of UNIPOWER Telecom, a division of UNIPOWER Corporation, are warranted for

two (2) years from date of shipment against defects in material and workmanship. This warranty

does not extend to products which have been opened, altered or repaired by persons other than

persons authorized by the manufacturer or to products which become defective due to acts of

God, negligence or the failure of customer to fully follow instructions with respect to installation,

application or maintenance. This warranty is extended directly by the manufacturer to the buyer

and is the sole warranty applicable. EXCEPT FOR THE FOREGOING EXPRESS WARRANTY,

THE MANUFACTURER MAKES NO WARRANTY, EXPRESS OR IMPLIED, INCLUDING, BUT

NOT LIMITED TO, THE WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICU-

LAR PURPOSE. As the sole and exclusive remedy under this warranty, the manufacturer, at its

option, may repair or replace the non-conforming product or issue credit, provided the

manufacturer’s inspection establishes the existence of a defect. To exercise this remedy, the

buyer must contact the manufacturer’s Customer Service Department to obtain a Return Material

Authorization number and shipping instructions. Products returned without prior authorization

will be returned to buyer. All products returned for repair must be shipped freight prepaid to

UNIPOWER. If the buyer fails to fully comply with the foregoing, the buyer agrees that no other

remedy (including, but not limited to, incidental or consequential damages for lost profits, lost

sales, injury to person or property or any other incidental or consequential losses) shall be

available to the buyer.