System information

GRAVITAS SABRE SERIES
INSTALLATION &OPERATING MANUAL
Manual No. SABRE-4 Page 47 11/27/07 sabre-man
B. Cable Installation
Install the Signal cable, Controller Can Bus cable and Controller Input cable as required.
C. Communication Interface connection
Connect the communication cable between the PC and rear communication interface.
D. Rear Cover Installation
Install the rear safety covers.
4.4.2 Inverter system Rear Removal
Remove the rear cover then remove the bus bars & signal cables.
Figure 31 Rear installation and removal of inverter system
Mains Line Bus bar
Output Line Bus bar
Inverter Output Neutral
Inverter Output Ground
Inverter Output Line
Battery Input- Bus bar
Battery Input+ Bus bar
Signal cable
Controller Input cable
Controller Can Bus
Communication Interface
Rear Cover