System information

GRAVITAS SABRE SERIES
INSTALLATION &OPERATING MANUAL
Manual No. SABRE-4 Page 46 11/27/07 sabre-man
B. Loosen the retaining screw.
C. Insert the controller module into the controller shelf.
D. Push on the front of the module until it is fully home. Secure the module to the shelf with the retaining screw.
4.3.2 Controller Module Removal
A. Loosen the retaining screw.
B. Remove the module from the shelf.
C. Once the controller Module is removed, replace with a dummy plate or another controller to avoid exposure to a
hazardous voltages.
Figure 30 Installation and removal of the controller module
4
4
.
.
4
4
I
I
n
n
v
v
e
e
r
r
t
t
e
e
r
r
s
s
y
y
s
s
t
t
e
e
m
m
R
R
e
e
a
a
r
r
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
a
a
n
n
d
d
R
R
e
e
m
m
o
o
v
v
a
a
l
l
4.4.1 Inverter system Rear Installation
Inverter system rear installation is carried out once the MBS & AC distribution unit, STS/Controller Shelf and Inverter
shelves have been installed in the cabinet along with the individual plug-in modules and the Communications Interface
Module if this has also been specified.
A. Bus bar installation
Install the Mains Input bus bar, Mains Output bus bar, Battery Input+ bus bar, Battery Input- bus bar, Inverter
Output Neutral, Line & Ground bus bars with the supplied retaining screws. All necessary parts are supplied as a
kit with each shelf.
Handle
Retaining screw
Controller Module