Installation manual

UNIPOWER

Installation manual PQ Secure

9.8.2 Configure PQSM basic settings with Windows authentication

Choose this section or section 9.8.1 depending on the intended log in method. Unipower normally

recommends using Windows Authentication (9.8.1)

Instructions on creating a Windows user for using Windows authentication login can be found under

section 11.7 Creating a service user in Windows

Note that the program must always be started with run as administrator!

Once PQSM is opened press the settings button (1).

Figur 64

Here you will have to fill in some required fields. See the picture below. Press Ok when all three tabs

are configured.