Installation manual

UNIPOWER

Installation manual PQ Secure

8.1.3 Setting the clock in the meter

Go to the View-Unit Status menu. To set the clock in the meter, click the Set Time button. Note that

the time, time zone and DST settings of the PC will be transferred to the meter. Be sure the PC has

correct time before setting the time in the meter.

If the meter is automatically downloaded by PQ Schedule to a database, never set the clock

manually. It is taken care of by PQ Schedule.

8.2 Physical installation

 Connect the GPS adapter to the UP-2210 Display Port.

 Tighten the securing screws on the sides of the connector so that the adapter does not

accidentally come loose.

 Connect the antenna cable to the adapter.

 In order for the GPS antenna to receive accurate time signals, it must have free sight to the

satellites. This is normally achieved by putting the antenna outside the building where the

measurement takes place, often on the roof of the building.

 If the conditions are good the antenna can also be placed indoors near a window. After a few

minutes the orange LED on the adapter will start flashing every second. This is an indication

of good reception from the satellites. If this doesn’t happen, the reception is to poor and the

antenna needs to be moved.

Time in PC

Time in meter