Installation manual

UNIPOWER
Installation manual PQ Secure
41
7.2.3 Recommended modem settings
The figure shows the typical settings [ATI4] in a US Robotics modem:
U.S. Robotics 56K FAX EXT Settings...
B1 E1 F1 L0 M1 Q0 V1 X4 Y0
SPEED=57600 PARITY=N WORDLEN=8
DIAL=TONE OFF LINE CID=0
&A3 &B1 &C1 &D2 &H1 &I0 &K1
&M4 &N0 &P0 &R2 &S0 &T5 &U0 &Y1
S00=001 S01=000 S02=043 S03=013 S04=010 S05=008 S06=004
S07=060 S08=002 S09=006 S10=014 S11=072 S12=050 S13=000
S15=000 S16=000 S18=000 S19=000 S21=010 S22=017 S23=019
S25=005 S27=001 S28=008 S29=020 S30=000 S31=128 S32=002
S33=000 S34=000 S35=000 S36=014 S38=000 S39=012 S40=000
S41=004 S42=000
LAST DIALLED #
7.2.4 Using HyperTerminal to configure the modem
Start HyperTerminal, for example as follows:
Start  Programs  Accessories  Communication  HyperTerminal
A window opens, where you start by entering a name for your connection and then click on OK. In
the next window, specify the COM port the modem is connected to (Not the modem type!).
Figure 30