Assembly Instructions

Stand the Bench up.
Place the Bench on a LEVEL surface.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit onto the Bench.
This pressure will help the Legs and Bench reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
If the Bench is not Stable it could lead to damage to the product.
Your Bench is ready for use.
This Bench can only be used on a flat, level surface.
Step 4
Position the Second Iron Legs(C) to Bench Seat Panel(A) as pictured above.
Secure the Second Iron Legs(C) to Bench Seat Panel(A) using Bolts(
①
), and Washers(
②
) with Allen
Key(
③
).
Do not fully tighten the Bolts.
Step 3
C
3
2
A
1
Page 5 of 6