Owner Manual
Tools Required
INSERTING AND TIGHTENING CAM-BOLT
SHOULDER
PANEL
Place Cam-bolt on pre-drilled
hole and screw in vertically.
Shoulder is flushed (on the
same level) with the panel.
Shoulder is above the panel.
P
ANEL
INSERTING CAM-LOCK
Insert Cam-lock
with arrow align
to Cam-bolt head.
WRONG
TIGHTENING CAM-LOCK
5/13
P
ANEL
Place Cam-bolt to the designated pre-drilled holes on the panel. Use a Phillips Screwdriver to
tighten Cam-bolt vertically until shoulder is flushed (on the same level) with panel. Do not
over-tighten or under-tighten.
CORRECT
Use a Flat-head Screwdriver to turn
Cam-lock clockwise so it locks onto
the head of the Cam-bolt. Turn until
it is snug (about 3/4ths of a turn)
-- over-tightening could damage
Cam-lock or/and Cam-bolt.
CAM-BOLT CAM-LOCK
Instructions For Fastening
CAM-BOLT AND CAM-LOCK
Align the arrow on the Cam-lock to the Cam-bolt
head and insert the Cam-lock. Ensure Cam-lock
is fully inserted.