Installation & Assembly

Turn the bench right side up.
Place the bench on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the bench.
This would help to align all the parts at all the joint areas.
Then get off the bench, and in a sequential manner, proceed to
tighten all blots.
To tighten the blots at the base of Top, do secure assistance from
your adult partner(s).
You may be required to turn the bench, to gain easy access to the
secure points.
Turn the bench in a synchronised manner.
CAUTION 1: When tightening these blots, tighten
sequentially.
DO NOT tighten any blots fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the blots and execute this
same process.
WARNING!! IF BENCH IS NOT STABLE , IT COULD LEAD TO
DAMAGING THE PRODUCT.
Ensure all blots are fully locked into position.
The bench is ready to be used.
Caution 2: This bench can only be used on a flat, level
surface.
Page 7 of 8