Installation & Assembly (Table)

Page 5 OF 6
Step 4
Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Screws in a sequential
manner, until evenly secured.
When tightening the Screws tighten sequentially.
Do not tighten any Screw fully and then move on towards the next one.
If there are still wobbles, loosen the Screws and excute the same
above process.
Your Table is ready for use.
This Table can only be used on the flat, level surface.
B
2
1
C
B
Put the tenon of Support Bar (C) onto the mortise of Leg Panels (B) and then
using Screw (①) with Allen Key (②) to secure these parts as shown in above
Step 3
picture.
You may need to push the Leg Panels (B), outwards, slightly to attach the
Support Bar (C).
Do not fully tighten the Screws.