Assembly Instructions

Step 5
Inspect Table and make sure all parts are adequately connected.
Your Table is ready for use
This Table can only be use on a flat, level surface.
Step 4
If wobble
Test again
30cm-50cm
Page 5 of 6
Place the Table right side up on a LEVEL SURFACE to see if it wobbles.
If it wobbles,lift the Table to some 30cm to 50cm height from the ground.
Keep your feet and tose weell away from the drop zone.
Drop the Table freely and vertically with the four legs,hitting the ground,at the same
time.This Drop Test will help to ensure that all the Screws and gaps all reach full alignment
status.
Test again for evenness on a LEVEL SURFACE .
If no wobbles are found, proceed to tighten all Screw.
CAUTION: When tightening the Screw tighten sequentiall.DO NOT tighten any Screw
fully and then move towards the next one. This could cause the frame to warp.
If there are still wobbles ,loosen the Screws and execute this same drop test.
If the Table is not stable, it could lead to damage to the product.