TABLE Caution : You must read this before you proceed CAUTION : This Table is NOT a TOY. Keep your child / children at bay in the process of assembly. For turning the Table and to prevent damage to the Table, 02 persons may be needed to execute this action.
Label Description QTY A Table Top 1 B First leg 2 C Second leg 2 D Wooden pad 4 Description QTY Label j k l m n Picture Picture Bolt (M8x50mm) Long Screw (M6x55mm) Short Screw (M5x40mm) Spring Washer (M8.5/14x2mm) Flat Washer (M8.
Before Beginning Assembly: Page 3 of 8
Overview Table top (A) Wooden pad (D) Second leg (C) First leg (B) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 2 k B Step 2.2 Step 2.1 A 2.1) With assistance from your adult partners, turn the Table Top (A) up side down as picture shown 2.2) Attach First Leg (B) to Table Top (A) as shown in picture above. Affix the leg (B) with the block by using Bolts (①), Spring Washer (④), Flat Washer (⑤) and Allen Key (⑥) as shown in picture above. Affix the leg (B) with the table top (A) by using Long Screw (②) and Allen Key (⑥) as shown in picture above.
Step 3 k C B A Attach Second Leg (C) to Table Top (A) as shown in picture above. Affix the leg (C) with the block by using Bolts (①), Spring Washer (④), Flat Washer (⑤) and Allen Key (⑥) as shown in picture above. Affix the leg (C) with the table top (A) by using Long Screw (②) and Allen Key (⑥) as shown in picture above. Repeat the same process to attach the remaining Legs (C) into the Table Top (A). Do not fully tighten the Bolts/Screws.
Step 5 With assistance from your adult partners, turn the Table back to normal flat ground EXERT pressure, floorwards, onto the Table. This pressure will help the Legs and Table Top reach alignment at all joints. Check for wobbles. In a sequential manner, gradually tighten all Bolts until evenly secured. Inspect the Table and make sure all parts are adequately connected. Your Table is ready for use. This Table can only be used on a flat, level surface.
Page 8 of 8
