Assembly Instructions

ManualsBrandsUnion Rustic ManualsOutdoor & Patio FurnitureBosley Rocking Chair with Cushions

Side Table

Caution: You must read this before you proceed

CAUTION : This Table is NOT a TOY.

Keep your child / children at bay in the process of assembly.

For turning the Table and to prevent damage to the Table, 02 persons may be

needed to execute this action.

Page 1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Side Table CAUTION : This Table is NOT a TOY. Keep your child / children at bay in the process of assembly. For turning the Table and to prevent damage to the Table, 02 persons may be needed to execute this action.
PAGE 2
Parts List Label Picture Description QTY A Table Top 1 B Left Leg 2 C Right Leg 2 Description QTY Hardware Label Picture ① ② ③ Bolts (M6x60mm) Washer (D20xT2mm) Allen Key 9 9 1 Assembly Preparation Before Beginning Assembly: Page 2 of 6
PAGE 3
Assembly Steps Overview Table Top (A) Left Leg (B) FRONT FACING Right Leg (C) This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
PAGE 4
Step 2 2.1 2.2 2.1) Place the Table Top(A) facedown as shown in picture above. 2.2) Attach the Right Leg(C) to Table Top(A) using Bolts(①), and Washers(②) with Allen Key(③) as shown in picture above. Do not fully tighten the Bolts. Repeat the same process for the remaining Right Leg(C). Step 3 Attach the Left Leg(B) to Table Top(A) using Bolts(①), and Washers(②) with Allen Key(③) as shown in picture above. Do not fully tighten the Bolts. Repeat the same process for the remaining Left Leg(B).
PAGE 5
Step 4 Stand the Table up, with assistance from your adult partner. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured. When tightening the Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one.
PAGE 6
Page 6 of 6