Installation & Assembly

 Page:  ‐3‐/3

StepA1:Unscrewtheknobnut(G)frombackplate(E)thengentlyremovemountingplate(A)
StepA2:
Secure back plate (A) to outlet box with mounting screws (C)
StepA3:Makewireconnections
   Connectwiresasbelowwiresconnectingshown.TAKENOTEOFYOURWIRECOLOROFFIXTURE,NEVERCONNECT 
WIRETOGROUNDWIRE
ConnectgroundwireaccordingtobelowchartConnectwiresaccordingtobelowchart 








Twistplasticwireconnectoruntilwiresaretightlyjoinedtogether,wrapeachconnectorwithapprovedelectricaltapeand
carefullytuckallwiresintotheoutletbox
StepA4:Putthebackplate(G)onthescrewsandsecurethemwithballnut(H)
StepA5:
Adjust arm (F) to be vertical with back plate (E)
Installbulb(Notincluded.Pleasedonotexceedthemaximumcapacityrecommendedonthesocket.)
4.
Checkeverythinginstalledproperly,thenyoucouldturnonthelight. 

CLEANING 
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
ORDERINGPARTS 
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture
can be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.