Owner’s Manual

6
ASSEMBLY INSTRUCTIONS
Light Kit Fitter Fan Pull Chain
Lens
Finial Cap
Finial
11. Restore the power at the main fuse or circuit breaker.
Assembly is complete.
11
10
10. Remove the nial cap and nial from the threaded
rod at the bottom of the light kit. Then, feed the pull
chains from the ceiling fan down through the grommets
in the bottom of the light kit and then through the
appropriate holes in the lens, nial cap and nial. Lift the
center hole in the lens and nial cap over the threaded rod
and secure to the light kit by screwing the nial onto the
threaded rod. Important: Orient the lens so the pull chain
takes a direct path from the grommet to the o-center
hole in the lens.
Note: You may substitute one of the extra nial caps and
nials if the pre-installed set does not match the metal
nish on your fan.
A
B
Switch
Housing Screw
Switch
Housing Screw
9
9. Using the three previously removed switch housing
screws, re-attach the switch housing to the tter plate (A)
or the switch housing cap to the switch housing (B).