Owner’s Manual

5
ASSEMBLY INSTRUCTIONS
9-pin
Connector
Single-pin Connector
Switch Housing
Switch Housing
A
B
8
A B
6
5
7
5. Install the E-26 base LED bulbs in sockets of the light kit
tter.
5. Slide the center ring of the fabric shade onto the
threaded rod at the top of the light kit. Then, place the
washer cover on the threaded rod and secure with the
lock washer and hex nut. Finally, drop the rubber washer
over the hex nut located in the washer cover.
7. Feed the wires from the light kit tter through the
center hole in the switch housing (A) or switch housing
cap (B) and secure by installing the lock washer and
hex nut.
8. Use the single-pin connectors to connect the wires from
the light kit to the wires in the switch housing (A or B)--
Blue to Blue and White to White.
If your fan has a tter plate (A), you may also need to
connect the 9-pin connector from the fan to the 9-pin
connector from the switch housing.
Rubber Washer
Hex Nut
Lock Washer
Center Ring
Washer Cover
Hex Nut
Lock
Washer
Lock
Washer
Switch
Housing
Switch
Housing
Cap
Hex Nut