Owner’s Manual

3
WARNING
READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE BEGINNING TO INSTALL THE
LIGHT KIT AND SAVE INSTRUCTIONS.
This xture is intended for use with an indoor ceiling fan. Not suitable for damp or outdoor locations.
The fan images and instructions in this manual are generic, but in most cases the installation will be easy to
follow. If unsure about installation, consult a qualied licensed electrician for proper installation.
The net weight of the light kit is less than: 4.4 lbs.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver
--Connect the equipment into and outlet on a circuit dierent from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Please note changes or modications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
To avoid risk of electric shock, be sure to shut o power at the main fuse or circuit breaker box before
installing or servicing this xture. Turning o the electrical power by using the light switch is not
sucient to prevent electrical shock.
Installation must comply with the national electrical code, ANSI/NFPA 70-1999 and local codes. If you
are unfamiliar with the methods of installing electrical wiring, seek the services of a qualied licensed
electrician.
To avoid personal injury, the use of gloves or protective clothing may be necessary when handling
xture parts with sharp edges.
To reduce the risk of re, electrical shock or personal injury, do not connect this xture to a ceiling fan is
not properly grounded.
To reduce the risk of re, electrical shock, or personal injury, each wire connector used with this light kit
should accept only one 18-gauge wire from the light kit and one 18-gauge wire from the ceiling fan.
Ensure the light kit is mounted to a ceiling fan that is mounted to an outlet box labelled “Acceptable for
fan support” and is secured to the building structure.
Wire colors from ceiling fan may not be the same color used in this manual. When in doubt, consult a
qualied licensed electrician to determine the proper wiring.
SAFETY INSTRUCTIONS