User's Manual

SECTION IV CONFIGURATION & DIAGNOSTICS
SM 7063 07/97 4-11
4.4.7 Configure Data Logger
To configure the Data Logger protocol and its associated transmission parameters, select item “7”
(Configure Data Logger) and press <Enter>. The following screen showing the associated submenus
will appear:
To select an item from this submenu, type in a menu item number and press <Enter>. To return to the
Main Menu, press <Esc>.
4.4.7.1 Set Protocol
The screen below shows the current data logger protocol selection.
The factory default protocol is “Data Logger Protocol” as defined in Section 3.16.1. The “Event
Recorder Protocol” is described in Section 3.16.2. To change the protocol, type in the desired
submenu item number and press <Enter>. To return to the Set Protocol menu, press <Esc>.