Specifications

AC6000
TM
Configuration Manual 91
UNION COMMUNITY Co., Ltd. 44-3 Hyundai Topics Building, Bangi-dong,
Songpa-gu, Seoul, Korea 138-050, Tel: [phone], Fax: [phone],
E-Mail:[e-mail], http://www.virditech.com
3.2.8.4.1. Screen Saver
The screen saver option will allow you to select the timeout value of the LCD after no activity; the
LCD will appear black during this time. This will conserve the lifetime of the LCD. The default is 1
minute. Selectable values are 1, 5, 10, 15, 20, 25, and 30 minutes. If the approach sensor,
function key, fingerprint cover, card scan or fingerprint scan is activated the LCD will automatically
turn back on.
3.2.8.4.2. Touchscreen Calibrate
If your Touchscreen responsiveness does not seem normal or your touching is not accurate you
may need to recalibrate the Touchscreen. Normally this is done from the factory, rare occasions
you may need to recalibrate. Press the button to recalibrate and a confirmation window will
appear. After you select OK the terminal will reboot and a Touchscreen calibration program will
run before the program starts again. Please touch each X on the calibration screen. When
Touchscreen calibration is performed you should use a stylus type pen device for selecting the
points on the LCD. Please remember to touch each point carefully, if you make a mistake you will
not be able navigate with the Touchscreen. You will need to perform a hardware reset calibration.
After touching ‘ok’ the terminal will automatically exit admin mode and within 3 seconds a
message will appear as below. Wait for the system to reboot, and then follow the calibration
instructions.