User's Guide

UBio-X Slim User Guide 25
UNIONCOMMUNITY Co., Ltd.
Addr : 12F, Munjeong Daemyeong Valeon bldg, 127 Beobwon-ro Songpa-gu,
Seoul, Korea (zip code : 05836)
Tel : [phone] , Fax : [phone],
E-Mail :[e-mail]; http://www.unioncomm.co.kr
3.5.1. Sensor
This menu is used to set the Sensor Mode, Capture Timeout,
LFD Accuracy, Sensor Brightness for the fingerprint sensor. And
when selecting the terminal basic sensor setting, this setting
will be applied to all users who are registered as selecting not
individual sensor setting.
Capture Timeout
This is the standby time for capturing fingerprint and it is
adjustable from 3 to 9 seconds. (Default : 5 seconds)
LFD(Live Finger Detection) Accuracy
This menu is used to set the level to inspect the fake finger
and to use it. This is graded from 0 to 3 as below.
‘Not use’(0), ‘Low’(1), ‘Middle’(2), ‘High’(3)
Camera Usage
This menu is set the camera using condition. For example, the
camera will be operated for authentication success when
selecting “Success”. And when selecting “All”, the camera will
be operated regardless of authentication success.
When selecting ‘Not Use’, the fingerprint image or other
suitable image will be displayed.
3.5.2. Card
This menu is used to set the Card authentication for terminal’s user.
Card Type
It is selectable among ‘Not Use’, ‘EM’, ‘MIFARE’, ‘HID26Bit’,
‘HID35Bit’, ‘HID37Bit’, ‘iClass26bit’, ‘iClass35bit’, ‘iClass37bit’.
Send Data
It is used to select the Wiegand Out data between ‘Card
Number’ to ‘User ID’. When selecting ‘User ID’, 4 digits User ID
will be out after authentication success via Wiegand Out but
when selecting ‘Card Number’, the card serial number(CSN)
will be out.
Site Code
This option is used only on selecting ‘User ID’ and it can be
out differently per each Wiegand bit between 26bit and 34bit
as below.
- Site Code for Wiegand 26bit : 0 ~ 255
- Site Code for Wigand 34bit : 0 ~ 32767