Quick Guide

Emergency Call
By pressing the red button on top of the radio, the radio will transmit the emergency alert
tone. Also the radio will sound the emergency alert tone via current channel. Users can
deactivate the function by pressing the red button again. If this function is set to repeat mode,
the emergency alert tone will go off repeatedly. To make the repeat mode off, please press
the red button. The function cannot become activated during scanning channels. This
function can be established by using the PC program and can change it at menu mode by
user.
In digital channels, my radio ID will be sent to other radios(UDR-100/400) if my radio ID is
pre-programmed into other UDR-100/400 radios. Then the alert tone will go off from the
other UDR-100/400 radios while the alert one goes off from my radio.
In analog channels, the alert tone only goes off from my radio.
☞
CAUTION`
Any trial to do Cloning between different manufacturers’ radios might cause a critical
malfunction
to the radios.
MENU SETUP
Function
F1 _ Up Arrow Key (Changing Menu)
F2 _ Down Arrow Key (Changing Menu)
F3 _ Menu / Enter
F4 _ ESC
2. How to Setup
19
1) Push the F3(Menu) button for 3sec to go inside of MENU
2) Then Changing Sub-menu with F1 or F2
3. Sub-Menu
1) CHANGING GROUP
2) SET TX Power
3) SET PASSWORD
4) SET ID
5) SET DTMF
6) SET PSC
7) SET TOT
8) SET VOX
9) SET SQUELCH
10) SET EQUALIZER
11) SET Whisper
12) SET SCAN
13) SET EMERGENCY
14) SET INHIBIT TX
15) SET KEY TONE
16) Earpiece Mode
17) SET DISPLAY
18) SET KEY LOCK
19) SET BCL
20) SET ID ALERT
21) LCD Contrast
22) Short Channel
20
23) SET Scramble
24) SET Compander
25) Information: Ver. information