Instruction manual

Rev. B MultiMode SPM Instruction Manual 69
Chapter 5 Head, Probe and Sample
Preparation
This chapter provides instructions for head, probe and sample preparation for imaging with the
MultiMode SPM. It describes how to remove and install the microscope head, how to change the
probe tipholder, how to mount the probe, load and position samples, and a general description of
how to engage and withdraw the tip. These procedures are common for most types of MultiMode
SPM imaging.
Please refer to the following sections:
• Initial Preparation for Contact AFM Imaging: Section 5.1
• Prepare the Sample: Section 5.1.1
• Load the Sample: Section 5.1.2
• Load Probe in Tipholder: Section 5.1.3
• Install the Tipholder: Section 5.1.4
• Laser Alignment: Section 5.2
• Method 1: OMV Method: Section 5.2.1
• Method 2: The Projection Method: Section 5.2.2
• Maximize the SUM Signal: Section 5.2.3
• Start the Microscope Program: Section 5.3
• MultiMode SPM Voltage Meters: Section 5.4