Instruction manual

Setup & Installation
Component List
Rev. B MultiMode SPM Instruction Manual 53
2. Connect computer cables (monitors, keyboard, mouse and controller) as shown below (see
Figure 3.2d).
Figure 3.2d Rear View of Computer on Standard MultiMode Systems
Note: Printers are also user-supplied. Serial ports COM1 and COM2 may be
configured by the user for peripheral equipment.
3. Connect cables to the back of the NanoScope controller: the power cable should be
connected to the controller’s receptacle on one side, the controller-to-computer cable on the
other. Connect the computer-to-controller cable to the back of the computer using the
connector labeled “To NanoScope Controller.” DO NOT connect this cable to LPT1.
CAUTION: DO NOT connect the power cable to a source of power yet.
NanoScope
controller
Power
Keyboard
Mouse
Control monitor
Display monitor
*Verify that voltage
selection switch is
set correctly for
your voltage.