Instruction manual
Rev. B MultiMode SPM Instruction Manual 49
Chapter 3 Setup & Installation
The following sections describe the setup and installation of your MultiMode microscope:
• Installing the MultiMode SPM: Section 3.1
• Component List: Section 3.2
• Unpack The System: Section 3.2.1
• Vibration Isolation: Section 3.2.2
• System Power Up: Section 3.2.3
3.1 Installing the MultiMode SPM
Set up the computer, main controller and two monitors as described in this chapter. Refer to support
note MultiMode and Bioscope Facilities Requirements (013-311-000) for facilities requirements
and environmental specifications.
3.2 Component List
If this is a first-time installation, verify you received all necessary components. The MultiMode
SPM system includes the following:
• MultiMode SPM base
• NanoScope SPM controller
• MultiMode SPM Instruction Manual (this document)
• Command Reference Manual
• NanoScope software restore CD
• NanoScope controller-to-MultiMode SPM cable, 37-to-25 pin, D-type
• Fiber optic illuminator, Fiber-Lite, Model 190