Instruction manual

Calibration, Maintenance, Troubleshooting and Warranty
274 MultiMode SPM Instruction Manual Rev. B
• Adjustment Screw Maintenance Procedure: Section 15.14
• Inspection: Section 15.14.1
• Remove Adjustment Screws: Section 15.14.2
• Inspect for Physical Damage: Section 15.14.3
• Clean Guide Bushings: Section 15.14.4
• Lubricate: Section 15.14.5
• Reinstall: Section 15.14.6
• Fuse Replacement Procedure: Section 15.15
• Vertical Engagement Scanners—Installation, Use, and Maintenance: Section 15.16
• Hardware Installation: Section 15.16.1
• Remove old scanner: If the SPM is engaged, disengage from the sample by
clicking on the Withdraw icon several times. Unplug and remove the SPM head
from the microscope. Remove the sample, then unplug and remove the old
scanner body.: Section 1.
• Install vertical scanner:: Section 2.
• Install scanner file: The vertical scanner is shipped with a CD containing its
corresponding scanner file; this file must be loaded into the computer’s EQUIP
directory. To load the file:: Section 3.
• Select scanner: Section 15.16.2
• Inspect scanner: Section 15.16.3
• Troubleshooting the Vertical Engagement Scanners: Section 15.17
• Scanner is not properly calibrated: Section 15.17.1
• Sample will not move (Tip “Up/Down” switch doesn’t work): Section 15.17.2
• Warranty: Section 15.18