Instruction manual

Electric Force (EFM) Imaging
Electric Field Gradient Detection—Preparation
Rev. B MultiMode SPM Instruction Manual 251
14.3.2 Jumper Configurations for systems with the Basic Extender Module
REMINDER: Power down the microscope and turn off all peripherals. Unplug the NanoScope III
control and power cables from the system before attempting to adjust jumper configurations.
As shipped from the factory, systems with the Basic Extender option, should have an original
baseplate jumper configuration as shown in Figure 14.3g.
Figure 14.3g Normal Jumper Configuration
(for systems with Basic Extender Module installed).
Ground
Analog 2
Unused
Auxiliary D (to NanoScope III controller)
To AFM Tip
Indicates jumpers
Analog 2
STM
Piezo Cap