Instruction manual

Scanning Tunneling Microscopy (STM)
Basic STM Operation
152 MultiMode SPM Instruction Manual Rev. B
Set Initial Scan Parameters
1. “Show All Items”: Before changing any parameters, you should display all of the available
parameters. If you cannot view a parameter in a panel, you might need to enable this
parameter.
a. Click the “minus box” in the upper left corner of the panel, and click Show all
items.
Figure 9.2a Select Show All Items
b. Ensure there is a “X” in the check box to the left of all parameters.
Note: Those parameters without a X will not display in normal Realtime mode.
Figure 9.2b Enable Parameters
c. Click the “minus box” in the upper left corner of the panel, and click Show all
items. The panel will once again appear in normal Realtime mode.
a.Click here
b.Select this
045
With “X”
Parameter
will display
Without “X”
Parameter will
not display
044