Operator`s manual

Sprite Installation and Operator’s Manual REV D1 Page 22 of 36
11.3.3 Unlock door on left side of enclosure and open to a maximum of 90º.
11.3.4 Remove all card stock from enclosure by rotating knurled knobs along transport path as required.
11.3.5 Vacuum as much dust as possible from inside enclosure.
11.3.6 Use compressed air to blow dust from ticket stock path grooves in transport assembly.
11.4 Using a SPRITE Cleaning Card
A cleaning card is available for the SPRITE which will clean the print head and the paper path via a menu selection. To
use the cleaning card (P/N 700-5014-200) follow these instructions:
NOTE
Follow the instructions on the cleaning card envelope. Do not open the envelope until you are
ready to insert the cleaning card into the Unit.
11.4.1 Press ONLINE/ENTER push-button to take the Unit to Offline/Menu.
11.4.2 Press the up or down arrow push-buttons to access MENU PRINT. Press ONLINE/ENTER push-button.
11.4.3 Press the up or down arrow push-buttons to access PRINT CLEAN. Press ONLINE/ENTER push-button.
11.4.4 The display will scroll to alert the operator to REMOVE ALL STOCK FROM INPUT AND EXIT BINS.
11.4.5 Once the stock has been removed, the display will scroll INSERT CLEANING CARD IN EITHER BIN.
11.4.6 Upon inserting the pre-saturated cleaning card, the coupon will move back and forth three times over the print
head and the magnetic read/write heads while the display scrolls CLEANING IN PROGRESS. The operator will
hear the drive rollers inside the Unit spin dry for about 10 seconds after each pass.
11.4.7 The cleaning card will appear at the front exit bin when the cleaning cycle is complete. Properly dispose of the
used cleaning card.
11.4.8 Press RESET/EXIT three times to return to Offline/Menu, then press ONLINE/ENTER to return to Online.
Cleaning card kits are available as needed: 700-5014-205K (Qty 5) and 700-5014-225K (Qty 25).