Operator`s manual

Sprite Installation and Operator’s Manual REV D1 Page 20 of 36
10.0.2 Press the RESET/EXIT push-button to try to clear the jam.
10.0.3 If the Document Path Jam message is cleared, press the ONLINE/ENTER push-button to continue operation.
10.0.4 If the jam condition persists, complete the following procedure:
WARNING
To prevent personal injury, remove power before clearing ticket stock jams.
10.0.4.1 Toggle the power switch to 0 (OFF) and disconnect the power cord from the rear of the Unit.
CAUTION
To prevent damage, do not force door open beyond 90º. The cabinet has door locks to limit
door opening to 95º.
10.0.4.2 Unlock and open the door on the left side of cabinet to a maximum of 90º.
WARNING
To prevent personal injury, do not touch motors when clearing ticket stock jams. After
extended Unit use, motors may become hot to the touch.
CAUTION
To prevent damage, do not hit or scratch the print head and encoder assemblies when
clearing ticket stock jams. Contact with hard objects can easily damage the print head and
encoder assemblies.
10.0.4.3 Remove the ticket stock causing the jam through the opening in the middle of the transport module.
10.0.4.4 Make sure that all the pieces of the ticket stock are removed from the transport module before
continuing.
10.0.4.5 Plug the power cord back into the Unit, toggle the power switch to I (ON), and reload the ticket stock as
described in the Installation Section.