Troubleshooting guide

Airport Bag Tag Printers Unimark 8500 Bag Tag Printer
34
12 Press ENTER and the following message is displayed:
MAINTENANCE
PRINTER ADJUST PROC.
13 Press ENTER and the following message is displayed:
STOCK OUT CALIBRATE
REMOVE STOCK-RESET
14 If paper stock is in the printer, remove it.
15 Press RESET.
16 Press ENTER. The following message is displayed.
TEST TOP OF FORM
RESET-TOP OF FORM
17 Load stock into the printer.
18 Press RESET and the paper will advance to the next Top of Form (TOF). The following
message is displayed:
POSITION TOF/HEAD
UP-BACKWARDS STEP
19 Open the cover and view the front of the print head.
20 Position the stock by pressing the Up Arrow or Down Arrow key until the printable area is
barely visible.
21 Press RESET and the stock will advance to the next TOF. If the stock is not in the desired
position, repeat the stock-positioning procedure.
22 Press ENTER and the following message is displayed:
REMOVE TAGS
EXIT - ABORTS
23 Tear off the paper stock. Stock will advance to the Exit sensor and back, the printer will display
the following message:
ADJUSTMENT COMPLETE
24 After several seconds, this message will appear:
MAINTENANCE
PRINTER ADJUST PROC.
25 Press EXIT until the following message is displayed:
MAKE CHANGES DEFAULT
(Exit=no) (Enter=yes)
26 Press ENTER.
27 Press EXIT until the following message is displayed:
ONLINE!
28 Your setup is complete.
Step Action (Continued)