Operator`s manual

6.3 Adjustments Menu
Menu structure may change depending on the specific customer firmware version.
Left Margin (dots) (1) Enter Value
Top Margin (dots) (2) Enter Value
Contrast (3) Enter Value
2 Inches Per Second
3 Inches Per Second
4 Inches Per Second
Adjustments Print Speed (4) 5 Inches Per Second
6 Inches Per Second
7 Inches Per Second
8 Inches Per Second
Normal
Print Direction (5)
Reverse
Print Sample
Notes: The following adjustments affect only the currently selected Document Type and can be set differently for each
Document Type.
Also note that all of these parameters are duplicated in the “Selected Type” Setup menu shown on page 4 and changing
these parameters in either menu affects the corresponding parameter in the other menu.
1. Left M shifts the entire printe
2. Top Margin shifts the entire printe (larger values) or to the bottom (lesser values).
3. Contra lects print darkness (hi t
quality on sensitive stock. Please choose the best, not necessarily highest, value for each Document Type.
4. Print S selects the print speed
acceptable print quality.
Not all ons have the full rang
5. Print Direction adjusts for whethe rst. This parameter
effectiv ly rotates the print image
argin d image to the right (larger values) or to the left (lesser values).
d image to the top
st se gher numbers create darker print). Note that higher contrast settings can decrease prin
peed . Note that some, less sensitive stocks may need to use lower print speed to achieve
versi es of speed selections showed here.
r stock is loaded into the ET6000 leading or trailing edge fi
e 180 degrees.
Page 9 of 38 71U-1415-100K; REV E ET6000 Operator’s Manual