Operator`s manual

8.0 Thermal Print Head, Platen, and Sensors
8.1 Cleaning the Thermal Print Head
1. Power the Unit off. CAUTION: Print
2. el release button and lift the
ont panel up and out of the way.
4.
nd remove.
5. Clean the print head heater element surface using
the print head cleaning pad (part of cleaning kit
P/N 700-5020-000). Verify that all label stock,
,000 inches of
rinting.
8.2 Cleaning the Platen
1. Power the Unit off. CAUTION: Print
Head is sensitive to ESD.
2. Press the front panel release button and lift the
front panel up and out of the way.
3. Pull the print head release lever forward and lift
the print head up away from the platen.
4. Grip the stock firmly from the rear of the Unit
and remove.
5. Clean the Platen surface using the Platen
cleaning pad (part of cleaning kit
P/N 700-5020-000). Verify that all label stock,
media residue, and any other contaminants are
cleared from the Platen.
Unimark recommends cleaning the Platen every
fifth box of stock or 100,000 inches of printing.
Head is sensitive to ESD.
Press the front pan
fr
3. Pull the print head release lever forward and lift
the print head up away from the platen.
Grip the stock firmly from the rear of the Unit
a
media residue, and any other contaminants are
cleared from the print head.
Unimark recommends cleaning the print head
every fifth box of stock or 100
p
Page 27 of 38 71U-1415-100K; REV E ET6000 Operator’s Manual