Operator`s manual
N
1. Get HCP server, otherwise the IP address is
ente le and accessible on the network for this
feature to be enabled, otherwise, the printer may not be able to communicate via its Ethernet interface. Also note that the Unit
needs to when enabl g or disabling this feature or when changing IP address, gateway subnet m res a key
be pressed on the front p e o complete.
2. Printer IP Address either shows the IP address obtained from th
the printer IP address ca e tered into this menu.
3. Gateway ither shows th G eway IP address obt the DHCP server if Get Dynamic IP Addres s nabl otherwise
the Gateway IP address a e ent ote t t Gateway nly releva t lar ne rks
where routers are in use. The Unit uses the Gateway IP Address to nd Ethernet packets that it determin s b host not
located o the local segm
4. Subnet M sk either shows t Subnet Ma from the DHCP f Get s ed, herw e the
Subnet M sk can be ent ed to this me at the Subn s only er networks where routers are in
use. The Unit uses the Subnet Mask to determine when to addr hernet packet to the Gateway for host on the cal
segment
Note: incorrect setup of either the Gateway IP Address or Subnet Mask may res lt in the i ability fo Unit to correctly
co its E t interfac
5. Primary DNS, Secondar DNS allows the user to specify the IP two DNS servers to uer whe reso ing
DNS names to IP addresses. The primary DNS server is queried first followed by t e secondary DNS server if he primary does
not return a result.
6. View Registered DNS, DN erver 1, NS Ser r re only ac Dynamic IP Address is enabled.
When en led, the Unit will obtain up to three DNS server IP ad resses from the DHCP server. These DNS server IP addresses
can be viewed in these m nus.
Note that the Unit can q e tal o en attemp g to reso e a DNS ame. Th first queries the
DNS ser r IP addresse as in order of S server . If less then three are assigned,
then the Unit will next query the DNS servers entered into the Prima and Secondary DNS server menu items
7. Host TC Port allows th p a dress v e to be set by the operator
8. MAC Ad ress This is a sp y nly of the MAC Address assign b ark to t ernet adapter inst le in th
The MAC address is also known as the Ethernet address, hardware addre , node ad ess, IEEE ddress, OUI, and others. It is
a 48 bit number unique t e Et
otes:
Dynamic IP Addr , when enabled, allows the Unit to lease an IP address from a D
red via the Printer IP Address menu. Note that a DHCP server must be availab
reboot in
l t
or ask, and requi
an
e DHCP server if Get Dynamic IP Address is enabled, otherwise
n b en
e e at ained from
ered into this menu. N
s i e
on
ed,
ger c n b ha the
se
IP address is o n
e
elong
two
s to
n ent.
a he sk obtained
nu. Note th
server i Dynamic IP Address i
relevant on larg
enabl ot is
a er in et M
ss an Et
ask i
e s not lo
.
u n r the
mmunicate using therne e.
y Addresses of up to q y n lv
h t
S S DNS Server 2, D ve
d
3 a cessible if Get
ab
e
u ry a to f three DNS servers wh
the DHCP server,
tin lv n e Unit
ve s signed by DN
ry
1 then 2 then 3
.
P e ort d alu .
d di la o ed y Unim
ss
he Eth
dr
al d is Unit.
a
o ach hernet adapter.
ET6000 Operator’s Manual 71U-1415-100K; REV E Page 16 of 38